For laboratory research use only. Every lot independently tested; certificates published by lot.

Epitalon specifications and molecular characteristics

The technical specification for Epitalon, the Epitalon research material supplied by Epitalon Labs: molecular formula C14H22N4O9, average molecular weight 390.35 g/mol, 4 residues, supplied as a lyophilized powder. Each item is explained below.

Last updated

Specification table

Epitalon specifications
ProductEpitalon
TypeSynthetic tetrapeptide
Molecular formulaC14H22N4O9
Molecular weight390.35 g/mol (average)
Length4 residues
SequenceAEDG
N-terminusFree amine (Ala1)
C-terminusFree acid (Gly4)
CAS number307297-39-8
FormLyophilized powder
Vial sizes10 mg
Purity specification≥95% (HPLC-UV)
Purity, current lots97.07%
Identity specificationConfirmed by HPLC retention-time match
Testing laboratoryILS Laboratories (independent)
StorageStore sealed, dry and protected from light at the temperature stated on the vial label. Allow a cold vial to reach room temperature before opening.
DesignationResearch use only

Current lot results against specification

Every current lot meets the release specification. Current lots test at 97.07% by HPLC-UV against a specification of ≥95%, and identity is confirmed by HPLC retention-time match on every lot.

HPLC-UV purity by lot. The scale runs from 96.0% to 100% so small differences are visible; every lot shown meets the ≥95% release specification.

All lot records or verify a lot.

Epitalon molecular formula

The molecular formula of Epitalon is C14H22N4O9.

Epitalon molecular weight

The average molecular weight of Epitalon is 390.35 g/mol. "Average" means it is calculated from natural isotope abundances.

Epitalon sequence

AEDG

Structure and modifications

Epitalon is linear with a free N-terminal amine and free C-terminal acid. It has no aromatic residues, so it absorbs weakly in UV above 220 nm; purity is measured at the peptide-bond wavelength (about 214 nm). Aspartate followed by glycine (Asp-Gly) is a sequence known to form succinimide and isoaspartate over time in solution, which is one reason the material is stored dry.

Physical form

Lyophilized powder, recorded as the appearance on every certificate. Lyophilization (freeze-drying) removes water, which slows most chemical degradation. What lyophilized means.

Purity and identity specifications

Epitalon Labs’ stated release specification is ≥95% HPLC-UV purity with identity confirmed by HPLC retention-time match against a reference standard. The current lot, KB-03392, reported 97.07%. How purity is measured, or how specifications fit into the quality and supply-chain process.

Analytical and testing methods

HPLC-UV for purity, HPLC-RTM for identity and laboratory quantitation for net content, performed on every lot by ILS Laboratories. Each lot is also screened for fentanyl by immunoassay. LAL endotoxin testing (USP <85>) and PCR microbial screening are reported for lots where they were run. Testing and quality control.

Research designation

Epitalon is designated research use only: supplied for laboratory research by qualified personnel. Research use only policy.

Buy Epitalon

10 mg vials. Current lot KB-03392 tested at 97.07% purity with identity confirmed by HPLC retention-time match against a reference standard. Current purchasing is available through Klow.bio.